Product Manual

18
3. Attach both running lights to frame at the
three holes just forward of the fenders. The
mounting stud goes thru the middle hole. the
wire goes thru one of the other 2 holes.
Tighten using the nut provided with the kit.
4. Stretch the wire out of the grommet to check
that the same length of wire is outside the
grommet as the white wire is long. Then coil
the wire so it is sure not to be pulled back into
the grommet.
5. Route the GREEN /
BROWN wire along
the RIGHT side of the
frame. Route the
YELLOW / BROWN
wire along the LEFT
as shown.
6. Use the clips provided to secure the wire inside
the frame channel.