User's Manual

Company Address: Room 601, Floor 6, Building F, Songbai Road 1008, Sunshine Community，Xili Street, Nanshan District, Shenzhen(518108)
Factory Address: Fl1, Bldg B, Wentao Industrial zone, Yingrenshiyongxin Village, Shiyan Street, Baoan district, Shenzhen, Guangdong, China (518055)
Tel: [phone] Fax:[phone]
Website: www.cdatatec.com
17
【WAN Connection name】Select ‘Add WAN Connection’
【Mode】Select ‘Bridge’
【Connection Mode】Select ‘Ipv4’; If there is Ipv6 in the network, we can select ‘Ipv4/Ipv6’.
【NAT】 Don’t check ‘NAT’ feature；NAT is mainly used for address translation function
of local network and external network. HGU ONU doesn’t deal with the packets
from the teminal, so we needn’t enable the NAT function.
【Enable Vlan】We can set this option according to your network plan. If there is vlan in
the network for Internet, we have to check ‘Enable VLAN’ option. If not,
we needn’t check this option, which will be VLAN transparent mode.
【Vlan ID】Configure this option according to our network plan.
【MTU】The default is 1500；we have to change to lower MTU, such as 1400, if we can
ping the DNS but not access the website via WEB broswer.
【Service Mode】 Select ‘Other’ or ‘Internet’；Normally, select ‘Internet’ for Internet or
flow testing; Select ‘Other’ for IPTV service.
【LAN DHCP Disable】Check this option；Normally, Terminal , connected to the HGU
ONU, will get an IP address from the upper DHCP server.
Therefore, we need check this option to avoid the terminal get
an IP from the ONU.
【Bind port】Bundel the physical ports (Lan port 1-4 and wireless) with Bridge WAN
connection.
Note: By default, all LAN ports and WIFI data are not bound by this WAN connection (a
LAN and WIFI SSID can only be bound to a WAN conection at the same time).