User Manual

Edition 09/2000
7
Press Ent button to change the open time for relay 2 and enter a time from 01 second to 99 seconds. Enter 00
for a latched output time. Then press Ent button to save the new time.
Press Nxt or Prv to select another door time relay and press Ent button to modify the time.
The third time relay indicates a default value of 1 second for relay 3.
Press Ent button to change the open time for relay 3 and enter a time from 01 second to 99 seconds. Enter 00
for a latched output time. Then press Ent button to save the new time.
Press Nxt or Prv to select another door time relay and press Ent button to modify the time.
To exit from programming mode press on PROG button.
Data Transfer (Menu 3)
Wiring Diagram
22 GND
23 Transmitting Data TX
24 Receiving Data RX
This message is displayed on the Control Unit, which will transmit the data.
Validate by pressing on the Ent button or press PROG to exit from the programming mode.
Wiring connection between Control Unit
A verification is done between by the control unit, which transfers the data.
UCA3 Control Unit
Data transfer to another
UCA3
Remote Control Unit
22 23 24 22 23 24