User Manual

RS02109/0814/CD 29 www.cdtechno.com
Stack Module Disassembly and Re-assembly Procedure
If a requirement to disassemble and re-assemble a module stack arises, follow the following procedure.
1. Starting with the uppermost module in the stack, remove the individual cells following the
instructions shown in Appendix D.
2. Repeat until all the cells have been removed.
3. Disassemble the stack modules. Transport the bottom stack module to the des ired
instal lation l ocation. Mark t he location of the floor anchors and install, again matching the
anchor holes in the floor-mounting bas e.
4. Be sure the floor mounting base or assembly is in position and level, an d t he n t orque t h e
f loor a nchor s. If the base is not le vel, us e shim s to level. A level base is particularly
importa nt for the stabilit y a nd safety of these high, narrow stacks (See Figur e A8).
5.
If the assembly requires additional modules, use the lifting slings. Place additional
modules, one at a time, on top of modules already in p la c e. Properly align modules and
mounting holes , and ins er t the M10 bolts, washers and nuts as shown in Figures A7 and
A8. When all bolts are in place, check that assembly is plumb and level, then tighten the bolts
to 40 ft-lb (55 N-m) using a torque wrench.
6. Reinstall the cells starting with the bottom module and working up. Perform the electrical
connections last.