User manual

24
p) Jumper
JP1 JP2 Jumper for JP1
The jumper must be plugged onto JP1 if you use rechargeable batteries to operate the PRO-BOT 128. When using normal batteries, you have
to remove the jumper from JP1! For this purpose, also see chapter 10. t.
JP2 is a 2 x 2-pole pin strip which serves for later connection to the PC (via the USB-RS232 adapter). Two pins each are soldered on to the top
and the bottom of the circuit board.
q) Socket board for C control PRO
X1, X2, X3, X4 = 2 x 8 socket strip

The socket strips are pressed against the circuit board from one side. Then solder on two diagonally opposing pins. Then align the
pin strips exactly vertical by possibly reheating the two pins.
Now insert the C-Control PRO unit with the right orientation into the 4 socket strips. Make sure that the pins are not bent and that all pins are
inserted in the corresponding holes of the socket strips. Broken pins of the C-Control PRO unit are not covered by the warranty/guarantee!