User manual

41
c) Programming cable (Voltcraft USB programmer)
Insert the CD included in delivery into the appropriate drive of your computer and start the installation program.
Do not connect the programmer to the USB port on your PC until the installation is completed.
Once the driver installation was successful, you can locate the programmer as a virtual COM port in the device manager.
Remember the COM-Port number (e.g. COM4). You now have to select this in the IDE of the C-Control PRO at "Options/IDE/Interfaces" to
establish communication with the C-Control PRO.
For further information about the IDE for the C-Control PRO, refer to the manual (see CD).
The catch on the plug of the USB programmer must point
in the direction of the arrow on the circuit board of the
main unit.
Voltcraft USB programmer Conrad item number: 197339
d) Commissioning and testing
Once you have installed the programming surface "IDE" and completed the assembly of the PRO-BOT128, you can proceed with the system
tests.
The following steps show you the usual procedure for handling the IDE and the PRO-BOT 128. First, copy the content of the CD to a new
directory, e.g. PRO-BOT128. Then open the IDE of the C-Control PRO.
At the first start, you still have to make some adjustments.
Set the programming interface of the C-Control PRO. To do so, move the mouse to "Options/IDE". At "Interfaces", select the COM port that was
assigned to the programming adapter (see c).