Instructions

43 C-Control Pro IDE

Testing Interfaces

The 4 pole pin strip X16 is to be used for testing purposes only and will not necessarily be armed

with components of any kind on every application board. For the user this pin strip is of no import-

ance.

One further testing interface is the 6 pole pin strip (two rows at 3 pins each) at JP4. This pin strip too

is only meant for internal use and may likely no longer be fitted with components in future board

series.

Technical Data Application Board

Note: Detailed information's can be found in the IC manufacturer’s PDF files on the C-Control Pro

Software CD-ROM.

All voltage specifications are referring to direct current (DC).

Mechanics

Overall measurements, appr.

160 mm x 100 mm

Pin pitch wiring field

2.54 mm

Environmental Conditions

Range of admissible ambient temperature

0°C … 70°C

Range of admissible relative ambient humidity

20% … 60%

Power Supply

Range of admissibly operating voltage

8V … 24V

Power consumption without external loads

appr. 125mA

Max. admissibly permanent current from a stabil-

ized 5V power supply

200mA

2.1.6.1 Jumper Application Board

Jumper

By use of jumpers certain options can be selected. This applies to several ports which are provided

with special functions (see Pin Assignment Table for M32). E. g. the serial interface is relized

through Pins PortD.0 and PortD.1. If the serial interface is not being used then the corresponding

jumpers can be removed and these pins will then be available for other functions. Besides the port

jumpers there are additional jumpers which are described in the following.

Ports A through D

The ports available with the Mega32 Module are inscribed in this graph. Here the right side is con-