Instructions

13 C-Control Pro IDE

tion Board

Mounting Orientation of Module MEGA32

The connector of Module Mega32 has been designed in such a way that faulty insertion of the Mod-

ule is not possible. The dismounting of the Module is performed by carefully lifting it from the socket

by use of a suitable tool. In order to avoid bending the contacts the lifting of the Module should take

place from various sides.

2.1.1.3 USB and serial

Installation of the USB Drivers

Please connect the Application Board to an appropriate power supply. A Standard 9V/ 250mA Mains

Plug-in Power Supply will be sufficient. The polarity does not matter since it is automatically correc-

ted by means of diodes. Depending on additionally used components it may later become neces-

sary to use a power supply with higher output. Establish a connection between the Application

Board and your PC by use of a USB cable. Switch on the Application Board.

Driver and Software of the C-Control Pro environment support no Windows Operating System be-

fore Windows 2000.

If the Application Board is connected for the first time then there will be no driver for the FTDI chip.

The following window will then be shown under Windows XP.