Instructions

117 C-Control Pro IDE

RELBUS-Board overview

The RELBUS-Board has two UNIT-BUS connections that are mutually connected 1:1. Thus, e.g.,

one of the connectors can be plugged to the Applicationboard or Mainboard, and the second port

can be used as a junction that connects to another UNIT-BUS module. The cable length must not

exceed 2m, since this will cause communication errors. However, when longer lines are needed, it is

helpful to put an I2C power driver (Order No. 198280) in-between.

The RELBUS-Board is powered by the UNIT-BUS with power. The consumer power supply is made

at the screw clamps labeled "+" and "-" . The UNIT-BUS is used in this module only as a communic-

ation interface, and for the supply of the digital electronic part of the circuit. Consumers are powered

externally via the ports "+" and "-"!