Instructions

3 C-Control Pro IDE

1.4 Intended use

The C-Control Pro Unit is an electronic device in the sense of an integrated circuit. It serves the

programmable controlling of electric and electronic equipment. Construction and operation of this

equipment must be in conformance with the valid European licensing principles (CE).

The C-Control Pro must not be galvanically connected to voltages exceeding the directed Extra

Low Protective Voltage. Coupling to systems with higher voltages must exclusively be performed

by use of components having VDE qualification. In doing so the directed air and leakage paths

must be observed as well as sufficient precautions for protection against touching dangerous

voltages must be taken.

The PCB of the C-Control Pro Unit carries electronic components with high frequency clock sig-

nals and steep pulse slopes. Improper use of the unit may lead to the radiation of electro-magnetic

interference signals. The adoption of proper measures (e. g. the use of chokes, limiting resistors,

blocking capacitors and shielding's) to ensure the observance of legally directed maximum values

lies in the responsibility of the user.

The maximum allowable length of connected wire lines is without additional precautions appr. 0.25

Meters (Exception: Serial Interface). Under influence of strong electro-magnetic alternating fields

or interference pulses the function of the C-Control Pro Unit can be detracted. If need be a reset or

a restart of the system may become necessary.

During connection of external sub-assemblies the maximum admissible current and voltage values of

the particular pins must be observed. The connection of too high a voltage, a voltage of wrong polar-

ity or an excessive current load may lead to immediate damage of the unit. Please keep the C-Con-

trol Pro Unit away from spray water or condensation dampness. Observe the safe operating temper-

ature range in Item Technical Data in the attachment.

1.5 Warranty and Liability

For the C-Control Pro Unit Conrad Electronic grants a warranty period of 24 months from the date

of billing. Within this time period faulty units will be replaced free of charge if the fault provable ori-

ginates in faulty production or loss on goods in transit.

The software in the operating system of the Microcontroller as well as the PC software on CD-

ROM is shipped in the form as is. Conrad Electronic can not guarantee that the performance fea-

tures of this software will satisfy individual requirements and that this software will operate free of

faults and interruptions. Conrad Electronic can further not be held liable for damages occurring dir-

ectly by or consequently to the use of the C-Control Pro Unit. The use of the C-Control Pro Unit in

systems directly or indirectly serving medical, health or life saving objectives is not authorized.

In case the C-Control Pro Unit incl. software does not satisfy your demands or if you do not agree

to our warranty and liability conditions you are to make use of our 14 days money back guarantee.

Please return the unit without use marks, in the undamaged original packaging and incl. all ac-

cessories within this time-limit to our address for refund or clearing of the value of goods!