Instructions

104Hardware

PCB Rear View

Is the base address of the LCD used (equal to the application board), the jumper must be re-

moved on the LCD board. See also LCD_SetDispAddr.

LCD Port Connectors

The Mainboard is connected to the LCD1602 Board via a 6-pin ribbon cable with pin header con-

nector (female). Since the cable may vary according to the application, we offer these components

for self-assembly using the following order numbers:

Ribbon cable RM1.27 0.05mm²: Order No. 607237

Pin header connectors 2x3 RM:2.54mm: Order No. 742063

Matching connection cable pre-assembled (length 35cm) Order No. 198876

Tip: The pin header connectors can be easily pressed together with a small vise. Cut the cable

to proper length and straight it in the plug (guide grooves in the plug), and then clamp between the

two vise jaws, and turn it carefully until the connector clicks into place.

Addressing: