Instructions

31
2. Switching at Incoming Call (INCALL1, INCALL2, INCALL3)
TheINCALLfunctionisusedtopermitspecicpeople(phonebook,grouprights)toswitchtherelaywithoutcausing
costsorneedingtodisclosethePIN.Theincomingphonenumber(transmittedbytheGSM-providerandusuallyin
theinternationalformat)iscomparedtothenumbersinthephonebookduringacall.Ifthenumberisunknown,the
callisrejectedatonce.Ifthenumberisknownandswitchingpermitted,theproductwillwaitforafewsecondsbefore
rejectingthecall.Theauthorisedpersonreceivestheinformationthatthedevicewasreached.
ThefollowingcommanddeneswhattodoatanINCALL:
SET <INCALL1/INCALL2/INCALL3> <TIME> #1513
 Time: Howlongshouldtherelayswitch,inseconds
   Maximumtime:300seconds
   Specialvalue:0=toggle(switchateverycall)
Todeterminethecurrentconguration:
TEST <INCALL1/INCALL2/INCALL3> #1513
Todeactivatethefunctionagain:
RESET <INCALL1/INCALL2/INCALL3> #1513
 Observe:
• ThischaptersetsHOWtoreact.ThechapterphonebookdenestoWHOMtoreact.Thisfunctionis
only active together.
• Onlytheactivationtimeisdened.Iftherelayisalreadyonwhencalling,itremainsonandisdeactivated
afterthespeciedtime.
• Whentoggling,thecurrentrelayconditionischanged.
• Cannot be used in BLOCK mode.
• Cannot be used for ALARM DISABLE.
• Thetimecanbere-triggeredbyanothercallbythesameoranotherperson.Therelayisactivatedand
the timer value set at each call.
• RELAYTIMEhasthehigherpriority.Whenthesettimeislower,RELAYTIMEisusedautomaticallyas
the switching time.