Instructions

16
ACTION:
Thefollowingactioncanbedetermined:
SET =switchon/activate/congure
RESET =switchoff/deactivate/defaultsettings
TEST =test/check/request
FUNCTION:
Thisisusedtoselectthefunctionyouwanttochangeorperform:
TEL =Createphonebookentry
NAME =Devicename
INCALL1=CongurationINCALLfunction(free-of-chargeswitching)
PARAMETERS:
Parameters are not required for every function andaction. Therefore, most „Reset“ actions have no parameters
while „Set“ actions without parameters are rather rare (what should be set to which value). A parameter may be the
following:
List: Thecustomermaychooseaparameterfromapre-denedlist,e.g.:DE,EN
 Writing:<DE/EN>
Number: Anintegerwithoutdecimaldigits,e.g.:60=time[minutes](SETIDLEALARM60#1513)
Examples:(ifthePINofthedeviceis1513)
SET G3 INCALL1 #1513 Group3canswitchOUT1(=INCALL1)
SET OUT1 #1513 SwitchesontheOUT1relay.
Note on the RESET command:
Ifafunctionistobeswitchedofforresetduetoanerror,thecorrespondingRESETactionmustbeusedwiththe
correspondingfunctionword!Thisactionisuniversallyapplicabletoallfunctions/textmessagecommandsandresets
the corresponding function to the default settings.
Example:
RESET OUT2 #1513  TheOUT2relayisswitchedoff.
More information:
• Capitalisation is not relevant; you may use capital and small letters as you wish.
• Every new command of the same function (2nd word) will overwrite the previous settings.
• Aftereverytextmessagecommand,thedevicewillreturnatestmessageanswertoconrmtheprogramming(ifthe
PIN in the text message command was correct and phone number conveying is activated).