Instructions

15
8. Conguration via Text Message
Toreceivethefullfunctionalscopeoftheproduct,itmustbeconguredrst.Theentirecongurationisperformed
by simple text message commands you send to the product (the phone number of the SIM card in the product) from
your mobile phone.
Thismethodmakesitpossibletoactivate,deactivateorchangethesettingsofyourdevicefromanywhere.
Alternatively,theproductcanbeconguredviatheUSBinterfaceusingPCsoftware(availableviawww.conrad.com).
 TheseoperatinginstructionsdonotdealwithcongurationviaPCsoftware.Thisonlydescribeshowthe
productcan becontrolledwith amobilephone, withoutanyother aids.For the sakeof completeness,
commandsthatareonlyavailableviaUSBarelistedaswell.Theyaremarkedspecically.
 Toprotectfromunauthorisedaccess,theproductgenerallyreactstoauthenticatedmessagesonly.Inatext
message,youauthenticateyourselfbyincludingthecorrectSIMPINoftheGXproduct(nottheoneofthe
mobile phone on which the text message was written).
 Foryourownsafety,theSIMPINnumbermustbechangedunderallcircumstancesaftercommissioning
oftheproduct.Thisisdescribedinmoredetailinthechaptercorrespondingtothecommand.
Introduction to the Command Format
Thetextmessagetoprogramthedeviceissetupaccordingtothefollowingchart:
<ACTION> <FUNCTION> <PARAMETER1> <…> <#PIN>
Examples:
 SET TEL [phone]  #1513  (phonebook)
 RESET INCALL1   #1513  (nocalls)
 TEST IN1   #1513  (requestIN1)
 ENABLE ALARM   #1513  (alarmson)
 DISABLE ALARM   #1513  (alarmsoff)
Important:
 EverytextmessagesenttothedevicemustendwiththePINsetasprotection.Without„#PIN“attheend
ofthetextmessage,itisdiscardedandnoansweringtextmessagewillbegenerated!
 Theindividualwordsandparametersmustbeseparatedbyaspaceeach.