User's Manual

Please make sure, that the unit is fixed securely to not become loose, even during a crash.
Please clean the mounting place with alcohol before taping it onto the glass. I
The device is including a high frequency cell phone antenna and other RF antennas and
therefore it must be placed at least 20 cm away from the passenger body in its usual
position. Please also locate it 20 cm away from sensitive electronic parts and wires of the
vehicle and from any other RF antenna.
Mounting of the fuel/ charging card and key fob detector unit „C-Intac“:
«C-Intac” must be placed in the glove compartment of the vehicle or somewhere else,
where touching passengers body in case of an accident is not possible or fullfill the
conditions according the relevant regulations of the coutry or usage (EU: 74/60/EwG see
above).
The reader can be attached either with double-sided heavy-duty adhesive tape or with Velcro tape.
The surface on which the tape must be cleaned with alcohol beforehand.
Configuration and synchronization with the CCOM
server
After connection, the device must be synchronized to assigne it to a vehicle and an organization.
Conditions: The installer needs an Android smartphone with our Convadis App "C-App". The app
can be downloaded from Google Play. Before use, an "App key" and a "User ID" must be entered
(to be obtained from the customer).
Synchronization steps:
- Create a configuration job for the "User ID" of the installer and the vehicle to be installed: This is
usually done in "CCom" by the central operator prior to installation.
- Open the app and/ or press "Refresh". The previously created configuration job is now loaded
onto the smartphone. It is visible in tab "Vehicles".
- Press the "Config. button" of C-Cmpact. The LED lights up red (max. 10 seconds).
Convadis AG, Stroppelstrasse 20, CH-5417 Untersiggenthal, Tel + 41 56 290 35 45, [e-mail], www.convadis.ch 9/10