User's Manual

C-Port includes an immobilizer option for for vehicle types with keyless go systems (start
button instead of ignition lock switch), as well as for transponder immobilizer systems.
Inserting the SIM card, place and install the main unit
and connect the cables:
The SIM card (Nano-SIM) is inserted under the main print. Before inserting, the device
must be disconnected from the power
supply by unplugging the main plug.
Press briefly at the little notch to
remove the SIM.
After you have removed the housing
cover by loosening the two black
housing screws, the cables can be
plugged into the edge of the device.
Attention: The cables for the central
lock system and for the immobilizer
can be configured as in- or outputs.
To ensure that the central lock
outputs in particular do not cause
short circuits on the connected
vehicle cables, please do not perform any log in/log out operations before
synchronising the device with the CCOM server (see below). During
synchronization, the correct vehicle-specific configuration is loaded.
Vehicle connections:
Before connecting the cables, disconnect the battery!
Convadis provides instattation manuals for various vehicle models for registered
customers on request. Als Convadis support for details (contact information see below).
Usually our vehicle-specific installation instructions contain several connection variants
(options). Select the appropriate installation variant, connect the cables accordingly, use
the appropriate main wiring harness and configure the device accordingly.
Connect all required wires from the main connection tree to the specified connection point
of the vehicle wiring according to the connection list in the vehicle-specific installation
manual (see above). Please make sure that the connections are good, and the wires are
fixed well and strain relief are secure.
Convadis AG, Stroppelstrasse 20, CH-5417 Untersiggenthal, Tel + 41 56 290 35 45, [e-mail], www.convadis.ch 5/10