User manual

C-COM Satellite Systems Inc. Page 79 of 128
iNetVu™ 7000 Controller User Manual
Revision 1.19
Should the entire Status Panel flash “RED” and “YELLOW”, a communication failure
between the PC and the iNetVu™ Controller has occurred. Ensure that the Controller is
powered, and that all USB drivers and cables (USB or Serial) are installed properly.
System Status
Displays current system environment
 System Running
Software is currently booting.
 System Idle
No operations are currently being performed.
 System Online
iNetVu™ system has found and locked onto the satellite, and is now ready for
surfing the Internet.
 ACP Testing
ACP Testing is being performed.
 Skew Adjusting
Polarization adjustment for receiving the optimal Signal Strength. Polarization will
rotate in both directions to locate the 3dB drop in Signal Strength, and then re-
center itself using the best possible Polarization Angle.
 Manual Operation
Manually controlled movement via Advanced Controls menu has been detected.
 Mount Testing
System test or demo being performed via System Test and Demo menu.
 Peaking on Satellite
System makes minor adjustments in positioning in order to receive optimal Signal
Strength.
 AZ Calibration
Azimuth Calibration is being performed.
 PL Calibration
Polarization Calibration is being performed.
 EL Calibration
Elevation Calibration is being performed.
 CP Calibration
Compass Calibration is being performed.
 Going to Position
An automatic movement command has been initiated (i.e. Find Satellite or
Deploy Antenna) and the antenna is moving into the designated position.
 Searching Satellite
Antenna is performing a search pattern to locate the satellite.
 Stowing Antenna
Antenna is being stowed.
 Antenna Stowed
Antenna is currently stowed.
 Unknown Status