Troubleshooting guide

iNetVu Troubleshooting Guide
C-COM Satellite Systems Inc.
Page 69 of 88
ERROR 0X8010 - Can't Stow (EL Limit)
Cause: This error will occur in firmware versions 7.2.2+ if the Elevation Stow switch fails to come on
during the last stow attempt. The controller will no longer allow the user to stow the antenna
automatically until the switch is fixed.
Solution:
a. Disconnect the sensor cable from the back of the controller. Using the manual controls on
the front of controller, move the platform to the stow position on all 3 axes of movement.
Reconnect the sensor cable.
b. Ensure the EL DN, EL ST, AZ ST, and PL ST are all activated.
Stow Position for 1200/1500/1800 (left) 750/980 (right)
c. Once the controller confirms all 4 switches are activated simultaneously, a message
indicating “EL Limit Fixed” will appear and the user can proceed stowing the platform
automatically.
If the Elevation ST does not come on in the Stowed position then the switch will need to be tested.