Troubleshooting guide

iNetVu Troubleshooting Guide
C-COM Satellite Systems Inc.
Page 68 of 88
Step 4: Testing the 7000 Controller.
a. Disconnect the sensor cable from the 7000 Controller and place the paper clip on the
connector shorting out the pins corresponding to the Switch you wish to test.
6&9 and 6&18 for Azimuth ST
7&9 and 7&18 for Polarization ST
b. From the iNetVu Mobile 7000 Controls screen does the AZ or PL ST come ON?
If YES, this concludes the Sensor Cable has failed
If NO, this concludes the 7000 Controller has failed