Troubleshooting guide

iNetVu Troubleshooting Guide
C-COM Satellite Systems Inc.
Page 67 of 88
Step 3: Testing the Sensor Cable.
a. Disconnect the sensor cable from the Platform and place the paper clip on the sensor cable
shorting out the pins corresponding to the Switch you wish to test.
A&C or (1&3) for AZ ST A&B or (1&2) for PL ST
b. From the iNetVu Mobile 7000 Controls screen does the AZ or PL ST come ON?
If YES, this concludes the Wiring Harness has failed
If NO, proceed to step 4