Troubleshooting guide

iNetVu Troubleshooting Guide
C-COM Satellite Systems Inc.
Page 66 of 88
a. Verify that the limit switch is connected to the wiring harness. Remove the switch from the
housing.
b. Place an external magnet at the tip of the switch as shown below. Please note if a magnet is
not available, the GPS antenna supplied with the mobile platform can be used.
c. From the iNetVu Mobile 7000 Controls screen does the AZ or PL ST come ON?
If YES, it concludes the limit switch is too far from the magnet and it needs to be re-installed and
brought closer to the magnet until the AZ or PL ST comes on.
If NO, proceed to step 2.
Step 2: Testing the Wiring Harness.
a. Disconnect the switch from the internal wiring harness and place a paper clip or a looped wire
in the connector going to the wiring harness.
b. From the iNetVu Mobile 7000 Controls screen does the AZ or PL ST come ON?
If YES, this concludes the Switch has failed
If NO, proceed to step 3