Troubleshooting guide

iNetVu Troubleshooting Guide
C-COM Satellite Systems Inc.
Page 38 of 88
The wiring harness for some platform versions has changed. To test the new wiring harness for
Polarization Tilt continuity disconnect the Tilt Sensor from the wiring harness and set the volt meter to
beep or continuity mode. Place one lead on pin (1, 2 or 3) to the wiring harness connector, and the
other lead to the corresponding pin (A, J or R) on the platform connector plate.
PL Tilt Sensor Circuit: MIL Spec Connector for 980 Platforms ver. 3.0+