Troubleshooting guide

iNetVu Troubleshooting Guide
C-COM Satellite Systems Inc.
Page 29 of 88
Grease Application to Azimuth Gear Assembly
Required Materials:
• Phillips Screwdriver
• Standard Grease Gun
• Multi-Purpose Grease (Operating Temperature Range: -40c to 65c)
** Recommended: Shell AeroShell Grease 33 for improved low-temp spec, or equivalent.**
Procedure:
1. Raise the iNetVu™ Mobile Platform.
2. Remove Elevation and Azimuth Covers.
3. Unscrew Azimuth Motor and lay on the Azimuth Plate.
4. Locate the three (3) Grease Fittings located on the Azimuth Plate. The two (2) Outer
Grease Fittings are located on the Azimuth Plate and one (1) Inner Grease Fitting is
located on the Azimuth Bushing inside the main assembly. One other grease fitting is
located near the clevis bracket under the actuator.
**Refer to the Figures below for the Grease Fitting Locations**
5. Rotate the Azimuth and apply grease to the two Outer Grease Fittings at several
locations ensuring that you have covered the entire mechanical range of the Azimuth.
6. Apply Grease to the Inner Grease Fitting.
7. Center the Azimuth and re-install the Azimuth Motor. Ensure the fasters and tightly
secured after installation.
8. Re-install the Elevation and Azimuth Covers.
740/750/950/980 Azimuth Plate Grease Fitting Locations (right) Detailed Grease Fitting
Locations (left)