Product Specs

Shenzhen Core (SMIC Technology Co., Ltd
SHENZHENSHI XINZHONGXIN TECHNOLOGY CO., LTD.
Address: Building A3, Shajing East Ring Industrial Zone, Baoan District, Shenzhen City Tel: [phone] / 81
/ 82 Fax:
0755-84736169
Company website: WWW.C-CHIP.COM.CN
12Page 4 of 13 13
C-3L-M.
FCC Statements
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module. For
15 B (§15.107 and if applicable §15.109) compliance, the host manufacturer is required to show
compliance with 15 while the module is installed and operating.
Furthermore the module should be transmitting and the evaluation should confirm that the module's
intentional emissions (15C) are compliant (fundamental / out-of-band). Finally the integrator has to apply
the appropriate equipment authorization (e.g. Verification) for the new host device per definition in
§15.101.
Integrator is reminded to assure that these installation instructions will not be made available to the
end-user of the final host device.
The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary label
stating the FCC ID of the RF Module, such as "Contains FCC ID: 2AG94C-3L-M
"This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired
operation."
"Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment."
the Integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the module integrated
into the host device.
Module statement
The single-modular transmitter is a self-contained, physically delineated, component for which
compliance can be demonstrated independent of the host operating conditions, and which complies with
all eight requirements of § 15.212(a)(1) as summarized below.
1) The radio elements have the radio frequency circuitry shielded.
2) The module has buffered modulation/data inputs to ensure that the device will comply with Part 15
requirements with any type of input signal.
3) The module contains power supply regulation on the module.
4) The module contains a permanently attached antenna.
5) The module demonstrates compliance in a stand-alone configuration.
6) The module is labeled with its permanently affixed FCC ID label.
7) The module complies with all specific rules applicable to the transmitter, including all the conditions
provided in the integration instructions by the grantee.
8) The module complies with RF exposure requirements.