Specifications

⚫ Antennas
This module is tested with PCB antenna, and the Max. antenna gain is 0dBi.
If you desire to increase antenna gain and either change antenna type or use same antenna type certified, a Class II permissive change application is required to be filed by
us, or you (host manufacturer) can take responsibility through the change in FCC ID (new application) procedure followed by a Class II permissive change application.
⚫ Label and compliance information
Please notice that if the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: “Contains FCC ID: 2AR7VC-2S” any similar
wording that expresses the same meaning may be used.
§ 15.19 Labelling requirements shall be complied on end user device.
Labelling rules for special device, please refer to §2.925, § 15.19 (a)(5) and relevant KDB publications. For E-label, please refer to §2.935.
⚫ Information on test modes and additional testing requirements
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or install module.
The module is limited to installation in mobile application, a separate approval is required for all other operating configurations, including portable configurations with respect
to §2.1093 and difference antenna configurations.
Test software access to different test modes: Wifi Test Tool v1.4.0
Testing item, Frequencies, Transmit Power, Modulation Type, test Antennas can be selected on the test script instructions.