Product Specs

Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
2.2 List of applicable FCC rules
FCC Part 15.247
2.3 Specific operational use conditions
This transmitter/module and its antenna(s) must not be co-located or operating in conjunction with any transmitter. This
information also extends to the host manufacturer’s instruction manual.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
It is “not applicable” as trace antenna which is not used on the module.
2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
compliance to FCC radiation exposure limits for an uncontrolled environment, and minimum of 20cm
separation between antenna and body.
The host product manufacturer would provide the above information to end users in their end-product manuals.
2.7 Antennas
PCB antenna; 0dBi; 2.402 GHz～2.480GHz
2.8 Label and compliance information
The end product must carry a physical label or shall use e-labeling followed KDB784748D01 and KDB 784748
stating “Contains Transmitter Module FCC ID: OMCBTAUD2”.
2.9 Information on test modes and additional testing requirements
For more information on testing, please contact the manufacturer.
2.10 Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.247) listed on the grant,
and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the
host not covered by the modular transmitter grant of certification. The final host product still requires Part 15
Subpart B compliance testing with the modular transmitter installed when contains digital circuity.