Instructions / Assembly

INSTALLATION & ASSEMBLEY
Remove the fixture and the mounting package from the box and make sure
that no parts are missing by referencing the illustrations on the installation
instructions.
1. Place the mounting wall plate(3) over the outlet box(1), align the mounting
slots of the wall plate with holes of the outlet box as shown. Use a level to
ensure the wall plate(3) is straight.
2. Mark the location of the keyhole slots of the wall plate on the wall.
Drill a ¼” holes at the narrow end of each keyhole slot marking on the wall.
Carefully hammer a wall anchor into each drilled hole.
3. Pull the supply wires (4 &5) and house ground wire (6) out from the outlet
box (1) before attaching wall plate to outlet box.Make electrical
connections, connect the black fixture black wire (10) to the black supply
wire (5) and the white fixture wire (9) to the white supply wire (4) using wire
nut (7). Connect the fixture ground wire (11) to the supply ground wire (6)
together using wire nut (7). Wrap all wire connections with electrical tape to
ensure secure connection.
4. Place the fixture base (13) over the mounting wall plate (3) and secure it
to the wall plate by using four Waterproof rubber（8）and fixture screws (12) .
5.This outdoor lantern has been permanently installed a photocell(18)
switch,photocell turns lantern ON at dusk and automatically turns OFF at
dawn,Note:don’t cover the photocell switch at anytime.
6. Installation complete, restore power at the circuit breaker and turn light
switch on to activate this fixture.
7.After installing the fixture, caulk upper 2/3 of wire connection enclosure to
mounting surface. Leave bottom 1/3 un-caulked for drainage of any water
that might leak into the enclosure. The manufacturer recommends a non-
drying exterior caulking material. A good example is a clear silicone rubber
sealant for exterior use.
Care and maintenance – Use dry and clean cloth to wipe the surface of the
fixture
1.OUTLET BOX (EXCLUDED)
2. OUTLET BOX SCREWS
3. MOUNTING WALL PLATE
4. WHITE SUPPLY WIRE
5. BLACK SUPPLY WIRE
6. HOUSE GROUND WIRE
7. WIRE NUTS
Turn off the main power at the circuit breaker before installing and servicing
the fixture to prevent possible injury from electric shock.
All electrical connections must be in accordance with local and National
Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical
wiring connections, obtain the services of a qualified electrician.
INSTALLATION INSTRUCTIONS
OUTDOOR WALL LIGHT
READ AND FILLOW SAFETY INFORMATION
8. Waterproof rubber
9. WHITE FIXTURE WIRE
10. BLACK FIXTURE WIRE
11. FIXTURE GROUND WIRE
12.FIXTURE SCREWS
13. FIXTURE BASE
14.PHOTOCELL
1
5
7
10
4
6
11
9
2
3
12
8
13
14