Instructions / Assembly

Please read carefully and save these instructions, as you may need them at a
later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in
order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National
Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical
wiring connections obtain the services of a qualified electrician.
Carefully unpack light fixture and hardware bag from box, and make sure
that no parts are missing by referencing the illustrations on the installation
instructions.
WLL61018
6. After installing the fixture, caulk upper 2/3 of wire connection enclosure to
mounting surface. Leave bottom 1/3 un-caulked for drainage of any water that
might leak into the enclosure. The manufacturer recommends a non-drying
exterior caulking material. A good example is a clear silicone rubber sealant for
exterior use.
8. #8-32 FIXTURE SCREW
9. #8-32 HEX NUT
10. WHITE FIXTURE WIRE
11. BLACK FIXTURE WIRE
12. FIXTURE GROUND WIRE
13. BACK PLATE
14. CAP NUT
INSTALLATION AND ASSEMBLY
1. Screw the fixture screws (14) into the mounting bracket(3), and
thread the hex nuts(15) into fixture screws. Secure the fixture
screws by tightening hex nut against the mounting bracket.
2. Pull the power supply wires out from the OUTLET BOX (1).
Attach the mounting bracket (3) to the outlet box(1) using
mounting screws(2).
3. Make wire connections, connect the black supply wire (5) to
black fixture wire (11), white supply wire (4) to white fixture
wire(10) and the fixture ground wire(12) to supply ground
wire(6) using wire nuts (7). Wrap all wire connections with
electrical tape for secure connection.
4. After wires are connected, tuck them carefully inside the outlet
box. Position back plate(13) over the outlet box and feed
fixture screws (8)
through two holes of the back plate until they protrude out
from the back plate approximately 1/4“ and secure using two
cap nuts(14).
5. Installation is complete. Turn on power at the circuit breaker.
Turn light switch on to operate this fixture.
1. OUTLET BOX (NOT INCLUDED)
2. MOUNTING SCREW
3. MOUNTING BRACKET
4. WHITE SUPPLY WIRE
5. BLACK SUPPLY WIRE
6. SUPPLY GROUND WIRE
7. WIRE NUT
INSTALLATION INSTRUCTIONS
OUTDOOR WALL LIGHT