Installation Guide

Function and Operation
MODES OF OPERATION
Mode Works at ON time
Shut off
delay time
Explanation
Day & Night
20 Sec /
Turn on the power at the main fuse or circuit breaker box, the
light will turn on immediately .Wait for about 20 seconds to
allow the sensor to warm up, then the light will automatically
enter into the TEST mode.
Day & Night
As motion
existing
5 Sec
The light will turn on at low-level brightness (30% brightness)
in test mode. When motion is detected ,the light will turn to
high-level brightness (100% brightness), and stay on as long
as the motion is continuing. The light will revert to low-level
brightness about 5 seconds after motion is no longer
detected.
There is one red LED on motion sensor flashing 3 times when
motion is detected.
Note: The time of TEST mode is approximately 120
seconds, then light will automatically enter into the
AUTO mode.
Night only
As motion
existing
2 Min.
At dusk, the light will turn on at low-level brightness (30%
brightness). When motion is detected, ,the light will turn to
high-level brightness (100% brightness), and stay on as long
as the motion is continuing. The light will revert to low-level
brightness about 120 seconds after motion is no longer
detected.
There is one red LED on motion sensor flashing 3 times when
motion is detected.
Until dawn, the lights will turn off in about 120 seconds after
the motion is no longer detected.
Note: If you don't want low brightness, turn off and turn on the
wall switch twice within 2 seconds when the fixture is running.
If you want to restart the low brightness, operate the wall
switch again in the same method. (See FIG.1)
Night only
Manual
override
operate
8Hrs or
Turn off at
dawn
In “AUTO” mode, to shift to the manual override mode,
turn the wall switch “OFF”, and turn it “ON” within 2
seconds. The light will turn on and stay on for approximately
8 hours, or until the Dusk-to-Dawn sensor detects light in the
morning. Once the Dusk-to-Dawn sensor detects light for
more than 60 seconds, the manual override mode will
automatically go back to the AUTO mode. (See FIG.2)
Note:
1. To make sure the above functions operate properly,
always keep the wall switch in the “ON” position
(including the daytime).
2. Turn the wall switch “OFF”, wait over 10 seconds and
then switch it “ON” again, the light will revert to
warm-up period again.
Manual Override Operating Diagram
Auto Mode
Manual
Override
Mode
Turn wall switch
OFF-ON within 0.5~2sec.
or
reset automatically after 8hours or at dawn
Turn wall switch OFF-ON
within 0.5~2sec.
FIG.2
Stand-by
mode
Test
mode
Auto
mode
Manual
override
mode
FIG.1
Low Brightness Operating Diagram
Start
low
brightness
Cancel
low
brightnes
s
Turn wall switch OFF-ON-
OFF-ON within 0.5~2sec.
Turn wall switch
OFF-ON-
OFF-ON within 0.5~2
sec.