User Manual

PK-00102787-1

Models

CPLGSTDBLW1

FCC Compliance Statement Compliance Notice:

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interfer-

ence in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accor-

dance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment oﬀ and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit diﬀerent from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of FCC rules. Operation is subject to

the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interfer-

ence that may cause undesired operation.

Changes or modiﬁcations that are not expressly approved by the

manufacturer could void the user’s authority to operate the equipment.

RF Exposure Information:

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. In order to avoid the possibility of exceed-

ing the FCC radio frequency exposure limits, human proximity to the

antenna shall not be less than 8 inches during normal operation.

RF Exposure Statement:

This equipment complies with IC RSS-102 radiation exposure limits set

forth for an uncontrolled environment. This transmitter must be installed

to provide a separation distance of at least 8 inches from all persons

and must not be collocated or operating in conjunction with any other

antenna or transmitter.

CAUTION - High Voltage - Disconnect power supply before servicing

Operation temperature: 0-40ºC

For Control of Electronic Ballast, CFL, LED Lamps

Type 1 Enclosure

IP20

Pollution Degree 2

Impulse Voltage: 1500V

Indoor use only.