Light Strip & Light Strip Extension Installation Guide
Easily Set Up Your Light Strip and Light Strip Extension Light strip and light strip extension sold separately LIGHT STRIP CONTENTS TRIM (IF DESIRED) Once the strip is trimmed, an extension cannot be added. 1 Measure 2 Cut to Length Make sure the strip is not plugged in at the wall when cutting. Smart Strip + Power Supply 1. 80-inch C by GE Smart Light Strip 2. Power Supply with plug LIGHT STRIP EXTENSION CONTENTS G 2000K R B G 2000K R B Smart Strip Extension 1.
STRIP BENDING OPTIONS LED LED LED Max 90° Curve with radius greater than 4 cm LED at bend LED 90° Connection of two strips at bend 90° 90° Curve Connector
INSTALL 1 EXTEND 1 Clean & dry surface (IF APPLICABLE) Attach B G 2000K R B B G 2000K R 2 Unplug from the wall prior to attaching extension. Remove plastic cover from end to link strips. NOTE: Light strip can be extended up to 32ft. Peel off tape B B G 2000K R G 2000K R G 2000K R PLUG IN POWER SUPPLY 3 Stick to surface Adhesive may damage walls or painted surfaces if removed. Press and hold strip to surface to ensure proper adhesion.
CONNECT USING C BY GE APP Download the C by GE app Add your Light Strip to the C by GE app Note: For out of home or voice control, C-Reach Smart Bridge is required. For set up help, visit cbyge.com/support Control your Smart Light Strip with your voice. Visit cbyge.com for set up instructions. Example Voice Commands: Amazon Alexa Alexa, turn off the living room. Alexa, good morning. Alexa, set kitchen to 50%.
CONNECT USING GOOGLE HOME APP 1 Plug in your Google Home or Nest Hub device. 2 Plug in your C by GE Light Strip in the same room as your Google Home or Nest Hub device. 3 Download the Google Home app to set up your Google Home or Nest Hub device and C by GE Smart Light Strip. For set up help, visit cbyge.com/support Control your Smart Light Strip with your voice. Visit cbyge.com for set up instructions. Example Voice Commands: Google Assistant Hey Google, turn on the lights.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
