A WARNING: RISK OF ELECTRIC SHOCK e e e Follow sate step carefully. L e Ensure all work mesh local and federal regulations.
Process MAGENTA Compatibility Requirements Rating 120V AC 60Hz Ventral wire is required {Wire Is usually white LED bulbs, Including GE smart LED bulbs, c org Vhblrcbyge.ccmlcompafiblmy Ground wire Is required (Wire is usually green, green LED up fo 150 WATS with a yellow stripe, ‘Works with compatible or caper) Incandescent/halogen up to 450 watts WI-Fi 80211 b/g/n @ 2.
You Got This! And we're here to help. For in-depth instructional videos and a guided tour through the installation, go to BEFORE YOU DO ANYTHING: Sep 1 Turn Off The Powers Tum off the power for the switch location at the circuit breaker box. Test existing switch li switch wrongful. ensurer not tum on. Now, follow these setup steps for a single gang switch.
STEP 2 Remove Your Old Switch 1. Remove the existing wall plate and switch from the wall. 2. Use voltage tester on the black wire to confirm power to the switch is off {recommended). 3. Before disconnecting the wires from the wall, label each with the provided wire labels. A Orchestral e grand wires are required If you font have dither wire, the C-start suite fs not impossible. 4. Disconnect wires and remove exiling switch.
Process MAGENTA Process BLACK PMS 001 GRAY 11 STEP 3 i Connect —h al: The Wires f n dado] B | 1. Connect the neutral {white) & Connect the ground (green) wire on the switch to the wire on the switch with the m neural (white label) wire from ground (green label) wire from the wall. the wall. _‘I 2. Connect the line (black) wire 5. Cap the on the switch to the line {black traveler wire (if applicable). label) wire from the wall. For 3-way switch setup, visit R 374 Inch 3.
STEP 4 Fit Wires Into : Wall Box Neatly push the wires back into the box, rotating the switch so It's oriented according to the image.
Process MAGENTA STEP 6 Turn The Power Back On After the switch is secured and face plate mounted, tum the power back on at the circulate breaker box. At the switch, the light ring will flash blue indicating the device is wired correctly and the device Is In setup meed. ® Fas Hal, Go To: a7 call 1-844-36C-BYGE Light ring will continuously flash vibe until the switch is added to the C by GE app. Light ring will flash red If the circuit is overloaded. Max load rating 150W LED and 450W incandescent/halogen.
Congratulations! You've completed the C-Start Switch installation. Next... & Download Google vole assistant (optional} Enable Your Voice Assistant Amazon Alexei e ll:l[" ity Alexei; saf kitchen fo 50%.
