Owner manual

Multiple Gel Casters

INSTRUCTION MANUAL

DCX-MC-4

DCX-MC-10

GCX-204

GCX-210

GCC-204

DCX4K Series

DCX10K Series

GCX-204K

GCX-210K

GCC-204-20K

GCC-204-33K

GCC-404K

GCC-410K

Kits:

Unit Only:

GCC-204-20

GCC-204-33

GCC-210

GCC-404

GCC-410

PAGE 1
INSTRUCTION MANUAL Multiple Gel Casters Kits: DCX4K Series DCX10K Series GCX-204K GCX-210K GCC-204-20K GCC-204-33K GCC-404K GCC-410K Unit Only: DCX-MC-4 DCX-MC-10 GCX-204 GCX-210 GCC-204 GCC-204-20 GCC-204-33 GCC-210 GCC-404 GCC-410
PAGE 2
UNPACKING UNIT ONLY SYSTEM: Please check that each DCX-MC-4, DCX-MC-10, GCX-204, GCX-210, GCC-204-20, GCC-204-33, GCC-210, GCC-404, or GCC-410 is complete with the following components: • • • Multi-Casting Chamber with lid, front panel with 5 captive thumbscrews, silicone gasket, backfill port connecting to central filling trough & face plate Polycarbonate separation sheets Acrylic shim sheet GCC-204 GCC-404 4-PLACE KIT: Please check that each DCX4K Series, GCX-204K, GCC-204-20K, GCC-204-33K, or GCC-404
PAGE 3
GEL CASTING INSTRUCTIONS 1. Place lid on bench and put the top end of the casting chamber (locating groove provided) on the lid so that it rests at an angle with the gasket facing up. 2. Start by stacking one separation sheet, followed by unnotched glass plate, spacer set, then notched glass plate. Repeat this sequence until all 4 sets (or 10 sets) are neatly stacked into the casting chamber. Place one additional separation sheet on the last glass plate. See figure 1.