TABLE OF CONTENTS #@ INTRODUCTION . ooh 02 8 02 OPERATION... 02 #@ MAINTENANCE . 03 # COMMON CAUSESFORFAILURE 03 # PUMP PART LISTS/TORQUE INSTRUCTIONS 03 B WARRANTY... 04 # PARTS DIAGRAM 05 # WRING DIAGRAM .. ooo 07 # TROUBLESHOOTING 09 # INSTALLATION CHECKLIST... 11 Make a permanent record of the Mode! and Serial Number of your compressor by filling in the fields above. You'll save time and expense by including this reference identification on replacement part orders.
INTRODUCTION The compressor you have purchased is a combination of nearly 100 different components, all of which have been carefully designed, engineered, and assembled to ensure a long, dependable, trouble free life. The product has been fully tested at the factory and has gone through quality control inspection prior to shipping. Like any mechanical piece of equipment, it is necessary to fully understand the proper use of its operation and application.
MAINTENANCE = DAILY MAINTENANCE: Drain moisture from your air compressor’s tank on a daily basis. (We recommend installing an automatic tank drain valve (EL CRDV-177K) to ensure that your tank is properly drained.) Bleed most of the air pressure from the tank before opening the drain valves, allowing all moisture to drain from the tanks. This reduces the moisture in your air lines and also helps reduce the risk of rust developing inside the tank. Check oil level in sight glass.
WARRANTY C-Ire Inc. warrants its compressors to be free from defects in material and workmanship subject to the following provisions: STANDARD WARRANTY DURATION: 12 months from date of purchase. EXTENDED WARRANTY DURATION: Three year Extended Warranties are available for the C-Ire A050, A075, A100, A130 and A150 series compressors, which extend the warranty from 12 months to 36 months from date of purchase.
Air Niter Fitter Belt Guard Belt Guard I I= Magnetic Starter Magnetic Starter Pressure Switch i.
WIRING DIAGRAMS (For units with Magnetic Starters) THREE PHASE SINGLE PHASE Wire to switch Ground Wire oT Wire to switch Power supply hookup Power supply hookup Lr Wire from the Wire from the motor STARTER BOX FLUE: CARLY NH) 07
OTR Dope Compressor will not operate No electrical power Loose wire connections Turn on power Tighten connection Compressor not mounted properly Pressure switch not making contact See pressure switch adjustment Overload/stripped Reset overload Knock occurs while compressor Connection rod bearings Replace rod is loading Wrist pins, wrist pin bearings Replace complete piston assembly Loose connecting rod nut Tighten Valves Replace Valves Compressor vibrates Mounting halts loose Tighten Level or shim compresso
OLE RRY ope Excessive oil consumption Too much oil in Crankcase Drain to proper level Improper weight of oil Replace with proper oil Obstructed Crankcase vent Replace dipstick or oil fill plug or Crankcase vent Dirty/plugged intake filter Clean/replace intake filter Warn piston rings Have unit serviced Scored cylinder Have unit serviced Overheating compressor Poor ventilation Relocate compressor Improper pump rotation Rewire for correct rotation Internal pump problem Have unit serviced Water in air receiver
INSTALLATION CHECKLIST In order to validate the warranty on your compressor, C-Ire requires this checklist be completed and kept for reference. | INSPECT FOR DAMAGE [J Carefully inspect the unit for damage that may have occurred during shipping. If damage has occurred, it should be noted on the freight carrier's bill of lading. {The manufacturer of this product is in no way responsible for damage ar losses resulting farm damage during shipping.
