User Manual

NÜO AIR Manual
Installation Equipment part
6
Installation NÜO AIR
To mount the reader on a plasterboard wall, the support should be screwed using CL82Z-3.1
x 16 countersunk screws (NOT INCLUDED).
SURFACE MOUNTING
The NÜO AIR reader can be surface mounted by using the surface support kit.
Instructions for assembly are as follows:
1) Mark the position of the 4 screws used to fasten the surface support to the wall.
2) Drill and place the wall plugs for the screws. Screws should have a diameter of 3.5 mm and a
minimum length of 25 mm (included).
3) Fasten the surface support to the wall.
4) Remove the reader from the surface support (see instructions for ush mounting).
5) Insert the ush mount support into the surface support.
6) Fasten the ush mount support to the surface support using the screws provided.
Once the reader module has been fastened to the wall, use the suction cup provided and
the detachable clip to remove it.