Installation Guide

EN EN
32
INSTALLATION INSTALLATION
Just power on( if there is socket behind the mirror, please connect power first and then hang the
mirroronthebracket)
1.Cutoffthepowercordplugaccordingto
theactuallengthrequired.
3.Undocumentedpersonnelsarestrictlyprohibitedtooperationbythemselves.
2.Themaingatemustbeshutdownduringwiringoperation.Power-onisstrictlyprohibited.
1.Wiringoperatorsmustbecertifiedelectricians.
Ifthe86lineboxisinstalledonthewallbehindthesmartmirror,itisamustforprofessionalstocut
offtheACcordplugandconnectthepowersupplybywiring.
Importantnotes:
Notethefollowing:
ACwiretrimmingwiringinstructions
2. Strip off the black insulating layer on the
outsidetoavoiddamagingtheinsulatinglayerof
the inner cable when stripping.Strip the
insulation layer of the inner cable to avoid
damagingthecorewhenstripping.
3.Wiring 4.Insulationtreatment.
Note:Acrimpingcapwithregularinsulationandflameretardantmustbeusedforinsulation.
BathroomProtectionAreasBathroomProtectionAreas
For installations in wet-rooms, such as bathrooms, specific installation guidelines apply. These
regulationsdifferbyregion.Pleasecontactaspecialistforthis.Thereforeelectricalinstallationsareto
beperformedbyaskilledtechnician.
ThisproductissubjecttoprotectionclassIP65.Thisprotectstheproductagainstsplashing
waterfromanyangle.
1.ThedistancebetweenthetwoholesforinstallationisA,andtheheightfromthegroundBmustbe
thesame.Measuretheinstallationlocationandmarkit.(ForthespecificsizeofAandB,pleasereferto
thesizetableaccordingtotheproductmodel,andtheinstallationheightaccordingtothesizetable,
thebottomofthemirrorfromthegroundis1100mm)
Productinstallation
30mm
A(Hole distance)
B(Hole height)
1100mm
Productinstallationsizetable
2. Punch two 8*40mm mounting holes in the
marked position, knock the expansion tube
into the hole, and the end of the expansion
tubeisflushwiththewall,andinstall2screws
intotheexpansiontube.
3. Fasten the inverted buckle behind the
smartbathroommirrorwiththescrewsfixed
onthewall.
Note: The load-bearing capacity of the
installationwallshouldbenolessthanfour
times the actual load-bearing capacity of
theproduct.
Model
Size（mm）
A B
KY600 350 1530
KY700 400 1630
KY800 500 1680
K5070 300 1720
K6080 400 1820
K1275 1000 1770
K1580 1340 1785
To guarantee electric safety and stability of functions during use, please ensure that the
productiseffectivelygrounded.