BASIN FAUCET INSTRUCTION
BASIN FAUCET TYPE Run the hot and cold valve at least 15 seconds to it before connect. 3/8’’ 3/8’’ INSTALLATION STEPS Flush piping system prior and after installation of fitting thoroughly.
Single Screw STEP 1 Install the screw STEP Install the hoses in sequence 2 STEP 3 Place the O-Ring at the bottom of the faucet STEP Put on the rubber gasket , then tighten the locking nut.
SPECIFICATION Application: Operation with unpressurized storage heaters is not possible. Use for indoor public places and common residence. Specifications: Minimum Flow Pressure: 0.05MPa Recommended Flow Pressure: 0.4MPa Operating Pressure: 0.1~1.0MPa Test Pressure: 1.6MPa Maximum Hot Water: 90°C/194°F Recommended Hot Water: 60°C Environment Temprature: 30°C-60°C/86°F-140°F If static pressure exceeds 0.5MPa, a pressure-reducing valve must be fitted.
