User Manual

ImpactXtreme Operator’s Manual 8 March 2013

What is %FS? Why would a user/administrator want to change the default value?
What are the consequences of change?
Device Time
Use these settings to change the way the detector displays times and dates.
Time Format
To change the default display format for time, choose an option from the drop-down menu. The
detector supports 12-hour and 24-hour clock formats.
Date Format
To change the default display format for date, choose an option from the drop-down menu. The
detector supports mm/dd/yyyy and dd/mm/yyyy formats.
Set Device Time
To synchronize the detector time with your computer’s time, choose Set Device Time.
Device Configuration Options
Enable Calibration Lock
Enable Fault Protection Lock
When Enable Fault Protection Lock is selected and a fault occurs during detector start-up, the
fault message is displayed continuously on the detector LCD. The detector will not enter normal
operation until the fault is cleared.
To review the fault details, select Historical Info from the Information menu on the detector. The
detector can be deactivated at any time during the fault condition.
Enable Force Calibration
When Enable Force Calibration is selected and sensors are past due for calibration, the sensors
must be calibrated during startup for the detector to enter normal operation.
You must enter a value in the Cal Interval (days) field on the sensor Profile Settings menu before
you select Enable Force Calibration.
Enable Flammable Menu
Enable PID Menu
Enable Wireless Mode Selection
Show Environmental Values on Review Mode