User's Manual

ConneX1 Operator’s Manual
35
Replacing the Sensor and Sensor Filter
16.2 Replacing the Sensor and Sensor Filter
WARNING
To avoid personal injury and/or property damage, use only

19.
Replacement Parts and Accessories on page 53
.
CAUTION
 The sensor has a high degree of resistance to common vapours and gases.
To clear a sensor, move the detector to a clean environment and wait 10 to
30 minutes.
 To prevent accidental poisoning of the sensor, refer to 1.3 Sensor Poisons
and Contaminants.
1. Press and hold
to deactivate the detector.
2. Remove the four machine screws from the rear shell.
3. Remove the rear shell.
4. Simultaneously push on the PCB release tab while lifting the PCB up
by the battery.