Specifications

Processing Parameters

'DELAY COARSE' Adjusts the delay in seconds, from 0 s to 12 s in 0.1 s steps.

'DELAY MEDIUM' Adjusts the delay in miliseconds, from 0 ms to 99 ms in 1 ms steps.

'DELAY FINE' Adjusts the delay in samples, from 0 smps to 47 smps in 1 smps steps.

The 'SCHEDULE' menu contains all the controls for the dayparting (REAL TIME CLOCK) preset switch-

ing.

'TIME' Sets the time and day of the DSPXtreme’s Real Time Clock.

'DAYPARTING ON/OFF: Enables or disables the scheduling.

'DP(X) ON/OFF' Enables or disables an individual daypart schedule.

'DP(X)' Sets the preset to switch to when this daypart is triggered.

'DP(X) START' Sets the start time day and time of the daypart. There is also an ‘ALL days’ option.

'DP(X) LENGTH' Sets the length in minutes that the daypart will run for.

The 'SYSTEM' menu contains all the system controls (non processing) such as remote control and secu-

rity

'TRIGGER PORT' This enables or disables the rear panel trigger (remote) port. The options are enabled and

disabled. More information is available in the trigger port section of this manual.

'REMOTE SOURCE' This selects the serial or the NET/LAN port as the remote control method. The default

option is Off.

The 'LAN CONFIG' menu contains the controls relevant to the LAN/NET port.

'IP' Sets the IP address of the LAN port.

'DG' Sets the default gateway of the LAN port.

'SM Sets the subnet mask of the LAN port.

'MA1' Sets the first half of the MAC address of the LAN port.

'MA2' Sets the second half of the MAC address of the LAN port.

'PORT' Sets the port number of the LAN port.

'ABOUT' DSPXtreme version number and design credits.

'BOOTLOAD' This option is used to FLASH update the software and firmware inside the DSPXtreme.

Further information on using this option is described in the documentation supplied with the upgrade.