Specifications

Processing Parameters
22
limiter will drastically reduce the loudness of your signal and should be used only if the regulations in
your country require you to comply with ITU BS.412. Otherwise set this parameter to off. The thresholds
are calibrated in dB relative to the ITU BS.412 reference.
'PILOT OUTPUT' This controls the 19KHz pilot output reference signal which is available on the
DSPXtra-FM back panel. Options are enabled and disabled.
The 'SCHEDULE' menu contains all the controls for the dayparting (REAL TIME CLOCK) preset switch-
ing.
'TIME' Sets the time and day of the DSPXtra-FM’s Real Time Clock.
'DAYPARTING ON/OFF: Enables or disables the scheduling.
'DP(X) ON/OFF' Enables or disables an individual daypart schedule.
'DP(X)' Sets the preset to switch to when this daypart is triggered.
'DP(X) START' Sets the start time day and time of the daypart. There is also an ‘ALL days’ option.
'DP(X) LENGTH' Sets the length in minutes that the daypart will run for.
The 'SYSTEM' menu contains all the system controls (non processing) such as remote control and secu-
rity
'LCD CONTRAST' Sets the contrast of the front panel LCD screen. The range is 0 to 25.
'LED CONTRAST: Sets the brightness of the front panel LED meters. The range is 1/4, 1/2, 3/4 and ful.
'TRIGGER PORT' This enables or disables the rear panel trigger (remote) port. The options are enabled and
disabled. More information is available in the trigger port section of this manual.
'FULL LOCK' This enables or disables the security code lock. The options are enabled and disabled. More
information is available in the code lock section of this manual.
'OUTPUT LOCK' This enables or disables the output code lock. The options are enabled and disabled. More
information is available in the code lock section of this manual.
'REMOTE SOURCE' This selects the serial/USB port or the NET/LAN port as the remote control method.
The default option is Off.
The 'LAN CONFIG' menu contains the controls relevant to the LAN/NET port.
'IP' Sets the IP address of the LAN port.
'DG' Sets the default gateway of the LAN port.
'SM Sets the subnet mask of the LAN port.
'MA1' Sets the first half of the MAC address of the LAN port.
'MA2' Sets the second half of the MAC address of the LAN port.
'PORT' Sets the port number of the LAN port.
'ABOUT' DSPXtra-FM version number and design credits.
'BOOTLOAD' This option is used to FLASH update the software and firmware inside the DSPXtra-FM.
Further information on using this option is described in the documentation supplied with the upgrade.
'19k REFERENCE OUTPUT' This controls the 19 kHz pilot output reference signal which is available on
the DSPXtreme back panel. Options are enabled and disabled.
The 'DELAY' menu contains controls for setting the MPX output delay in order to align it with digital part of
HD Radio (IBOC) transmission.