Specifications

Meters And Status LEDs
9
dSPXmInI-hd meterIng
The DSPXmini-HD metering is accesable at any time by pressing the middle soft key on the front panel. It
shows instant IO meters as well as all processing metering.
I/O metering
The input meters show the level of the input audio. The meters are ‘hooked in’ to the DSP code after the input
level selection and mode options.
The output meters represent the level in dB below full scale output. This output level is the peak output level of
the processing and has nothing to do with the actual output level set by the analogue and digital output level
options.
The output meters show a smaller dynamic range compared to the input ones. This reflects the smaller dynamic
range of the audio once processed by the DSPXmini-HD. If we were to have used the same scale as the input
metering we would not see a lot of activity on the bars.
The IO meters follows an approximation of the PPM level of the audio waveform.
Multi-band AGC
The first four gain reduction meters show the gain reduction of the multi-band AGC. The range shown is -21dB
to +21dB in 3dB steps.
There is only one meter per stereo channel and the value shown is the largest gain reduction of the left and right
channels. Under normal operation (with a stereo audio feed) this is fine but you may observe strange metering if
the channels are not very balanced in level.
Multi-band limiter
The second four gain reduction meters show the gain reduction of the multi-band limiter. The range shown is
0dB to -15dB in 1dB steps.
There is only one meter per stereo channel and the value shown is the largest gain reduction of the left and right
channels. Under normal operation (with a stereo audio feed) this is fine but you may observe strange metering if
the channels are not very balanced in level.
StatuS LedS
The DSPXmini-HD front panel contains three status LEDS.
REMOTE: Indicates that the DSPXmini-HD is currently talking to a remote computer. This will flash dur-
ing an update of the firmware or remote control with the remote control application.
AES/EBU: Indicates the presence of a valid AES/EBU signal connected to the digital audio input of the
DSPXmini-HD.
EDIT: Indicates that you are currently editing a parameter
LOAD PRESET
REMOTE
AES/EBU
EDIT
UP
LOAD
SAVE
DSPXmini
OUTPUT
PROCESS
INPUT
UP
LOAD
U1=BASS FACE
INS
DEL
DONE
ENTER PASSCODE
INS
DEL
DONE
ENTER NEW PASSCODE
3779
U2=ROUND FACE
U3=CLASSICAL 3
(A)
SAVE PRESET
UP
GO
U1=BASS FACE
U2=ROUND FACE
U3=CLASSICAL 3
(A)
INS
DEL
DONE
NAME PRESET U2
MY PRESET 3
UP
LOAD
SAVE
DSPXmini
OUTPUT
PROCESS
INPUT