Specifications

Remote Control Application

Remote application connection screen

NET/LAN PORT

The DSPXmini-HD is equipped with a NET/LAN port for ease of remote control, setup and monitoring.

CONTROL OF THE DSPXmini-HD BY THE NET/LAN PORT

If you wish to use the NET/LAN port to control the DSPXmini-HD follow the steps below

1. Connect a cat 5 cable to the RJ45 port on the DSPXmini-HD and plug this into your network hub/switch. A

Xover cable can be used to connect directly to a PC if you don’t have a switch or hub.

2. . Navigate to the ‘REMOTE SOURCE’ parameter contained in the system menu on the DSPXmini-HD and

select the Network option.

3. Run the DSPX

mini-HD remote application and you will be presented with a connection screen (see below) .

Select the Ethernet option.

4. A password needs to be entered, regardless of password settings on the DSPXmini-HD itself. A password still

needs to be entered even if the passwords on the DSPXmini-HD have been disabled.

5. Click connect on the application and you should receive a ‘please wait’ box while the information is retrieved

from the DSPXmini-HD. Once connected you are then free to control the DSPXmini-HD with the remote appli-

cation. Further information on the remote application is contained on the following pages. If the DSPXmini-HD

remote application does not connect or disconnects after a few seconds then it could be that the password is

incorrect. The default password for the DSPXmini-HD is 3779. You are free to change these on the DSPXmini-

HD itself (see information on password control elsewhere in this manual)

PASSWORD ACCESS

The DSPXmini-HD contains two levels of password control, a high level password which blocks access to all

areas of the DSPXmini-HD and an ‘Output’ level password that allows access to all areas of the DSPXmini-HD

except the output menus that contain the output mode and level settings. The ‘Output’ level password could be

given to programme controllers to adjust the processing knowing that the transmission will remain compliant as

there is no way for the user to adjust the peak output level of the DSPXmini-HD.

These passwords can only be set from the DSPXmini-HD front panel and are located in the system menu.

The password box is located on the connection screen to the right of host and port input boxes.

The default (factory shipped) passwords for the two locks are ‘3779’. The remote application will always default

to this when it is run, unless you change it. Some users may find the output lock set to ‘0000’ Try this is 3779

does not let you access the output menus.