Specifications

Getting The Sound You Want
24
gettIng the Sound you Want
While the DSPXmini-HD can help you obtain the sound that you want we must always take into account the limi-
tations presented to us by the transmission channel. The biggest problem we have is the maximum peak level
that can be handled by that transmission channel, and for digital broadcasting services that is 0 dBfs.
The trade off in any audio processor is loudness vs. quality. The mark of how good a processor is, is how loud
the processor can go while maintaining sufficient quality. It is up to you where this loudness / quality trade off
point is set. This point is also usually market and format dependent.
In the effort to squeeze as much bass and high frequency energy into the peak limited channel we must make
compromises. Bass takes up a lot of room in the waveform and pursuit of a 'mega bass' type sound will leave
you less room for high frequencies. When processing aggressively we usually will have to accept a certain level
of bass distortion in making room for high frequencies or we will have to accept a certain level of high frequency
distortion if our desire is lots of clean loud bass.
If your aim is a cleaner sound and a slight loss of loudness is not important then it is easier to get the tonal
characteristic you're after without distortion. Lower final limiter drives will provide you with clean bass and crystal
clear razor sharp high frequencies. The choice is yours.
More LOUDNESS
Loudness can be increased in several ways.
Multi-band AGC:
Increase the drives to the bands.
Speed up the release times, making them faster.
While it is possible to create a strange response in the multi-band AGC, it is hard to produce distortion
because whatever gets through the AGC is dealt with by the following peak limiters
Multi-band Limiters:
Slow down the peak attack times, letting more through to the peak limiter.
Speed up the release times of the average release time constants.
Slow down the average attack time so that the peak time constants dominate the control signal providing
faster control.
Extra loudness can be obtained by working on only a single or a couple of the above suggestions. You are
likely to run into trouble if you 'crank up' all of the above settings. You are likely to generate excessive distor-
tion in the final limiter and generate a fatiguing sound if you're not careful. Less can be more! Make small
changes and compare against the settings of the factory presets if you find you have lost your way some
where.
Peak limiter:
Increase the look-ahead limiter drive
WE SUGGEST ONLY SMALL MODIFICATIONS FROM FACTORY PRESET SETTINGS IF YOU ARE
MODYFYING LOTS OF THE PARAMETERS. IF YOU ARE ADJUSTING ONLY A COUPLE FROM THE
ABOVE SUGGESTIONS THEN YOU PROBABLY HAVE A BIT MORE LEE-WAY. IT IS VERY EASY TO
LOSE YOUR WAY ONCE YOU START 'CRANKING' LOTS OF DIFFERENT SETTINGS.
More CLARITY
We can obtain extra clarity and quality in several ways.
Multi-band AGC:
Slow down the release times, making them slower.
Multi-band Limiters:
Speed up the peak attack times, letting less through to the peak limiter.
Slow down the release times of the average release time constants.
Speed up the average attack time so that the average time constants dominate the control signal providing
slower control.
Look-ahead limiter: