Specifications

Remote Control Application

CONTROL OF THE DSPX-FM BY RS232 or USB (SERIAL)

If you wish to use the RS232 or USB port to control the DSPX-FM follow the steps below

1. Connect the supplied serial cable to the rear RS232 port or a USB cable to the front USB port

2. Navigate to the ‘REMOTE SOURCE’ parameter (also in system) and select the serial option

3. Run the DSPX-FM remote application and you will be presented with a connection screen (see image). Select

the COM port on your computer that you have plugged the serial cable into or select the virtual comm port cor-

responding to the USB cable.

4. A password needs to be entered, regardless of password settings on the DSPX-FM itself. A password still

needs to be entered even if the passwords on the DSPX-FM have been disabled.

5. Click connect on the application and you should receive a ‘please wait’ box while the information is retrieved

from the DSPX-FM. Once connected you are then free to control the DSPX-FM with the remote application.

Further information on the remote application is contained on the following pages. If the DSPX-FM remote appli-

cation does not connect or disconnects after a few seconds then it could be that the password is incorrect. The

default password for the DSPX-FM is 3779. You are free to change these on the DSPX-FM itself (see informa-

tion on password control elsewhere in this manual)

NET/LAN PORT

The DSPX-FM is equipped with a NET/LAN port for ease of remote control, setup and monitoring.

CONTROL OF THE DSPX-FM BY THE NET/LAN PORT

If you wish to use the NET/LAN port to control the DSPX-FM follow the steps below

1. Connect a cat 5 cable to the RJ45 port on the DSPX-FM and plug this into your network hub/switch. A Xover

cable can be used to connect directly to a PC if you don’t have a switch or hub.

2. . Navigate to the ‘REMOTE SOURCE’ parameter contained in the system menu on the DSPX-FM and select

the Network option.

3. Run the DSPX-FM remote application and you will be presented with a connection screen (see below) .

Select the Ethernet option.