User Guide

50 – BuzzEdit

™

, Inc.

Note: The ability to change the center of your stretch is

very handy. For example, if you need to stretch an area of your

design a bit to eliminate a gap between regions of your design,

you would position the center of the stretch on the stationary

edge. As you stretch your selection, you will see it growing

away from this center.

Drag the circular arrow arms to

change the angle of stretch

Change the angle of stretch for your

selection by dragging the circular arrow

arms that are attached to the selection

boundary. The percentage rotation is

displayed on the bottom status bar.

Stretch your selection by pulling on the

dashed portion of the selection boundary.

When your cursor is positioned correctly,

your cursor will look like the one in the

example to the right.

Stretch selection by

pulling on dashed portion

of selection boundary.

You can also stretch your selection using the Tools > Stretch…

command. This procedure is described in the BuzzEdit

™

Command

Reference on page 151.

Convert Design Format

Different embroidery machines require different design file formats.

If you are going to use another machine's designs, you will need to

convert the design to a format your embroidery machine can

understand. BuzzEdit

™

will convert stitched-based design files from

one design file format to another.

You can convert your current design to the file format of your choice

by choosing Tools >Convert Design Type…