User Guide

, Inc. 2 | Manipulating Stitches - 47

You can toggle between a custom center and the center of

the selection by clicking on the Custom Center toolbar button

located on the main toolbar.

Rotate the angle of mirror

by dragging the boundary

You can change the angle of reflection for

your selection by dragging the circular

selection boundary. This changes the angle

at which your selection is flipped so that you

can flip your selection diagonally. The angle

of the mirror is shown by the line dividing the

circular selection boundary. The percentage

rotation is displayed on the bottom status

bar. In this example, the angle of mirror is

set to 45 degrees clockwise.

Flip your selection by clicking on the mirror

shown by the line that bisects the circular

selection indicator.

Click on the mirror to flip

your selection

You can also flip your selection using the Tools > Flip… command.

This procedure is described in the BuzzEdit

™

Command Reference

on page 152.

Resize

Is your design a little too big to fit in the embroidery hoop? Perhaps

the design would sew better if the stitches were not quite so close

together. In BuzzEdit

™

, resized designs and selections contain the

same number of stitches as the original. Shortening the stitches

reduces the physical size of the selection and lengthening the

stitches increases the physical size of the selection. If you reduce an

area too much, the stitches will be too close together to sew

properly. If you increase the physical size of an area too much, the

area will be sparsely sewn.