User Guide

Copyright © 2000 Buzz Tools
®
, Inc. C | Common Multi-Hoops – 169
The Giant Hoop-it-All
™
is
being sewn in the first
position.
The hoop bracket is
moved and the hoop
frame rotated as needed
to sew the various
segments of the design.
Here is our completed
design after all twelve
design segments have
been sewn.
For most machines, the Giant Hoop-it-All™ has an area in the
center that can only be reached by removing the fabric and
re-hooping by hand.
The standard Giant Hoop-it-All™ can only work on those embroidery
machines where the embroidery arm is on the right (the same side
of the embroidery machine). If the embroidery arm on your machine
is on the left side, the width of this embroidery frame would hit the
machine body!
Hoop-it-All™ has also created the Giant-L Hoop-it-All™ for use on
embroidery machines where the embroidery arm is located on the
left. This is typically found on a sewing / embroidery combination
machine. The Giant-L Hoop-it-All
™
can sew on either side of the
frame, but is smaller than the Giant Hoop-it-All
™
due to the location
of the embroidery arm.
Mounting bracket
slides to any
position.
Both the Giant Hoop-it-All
™
and the Giant-L
Hoop-it-All
™
embroidery frames have a sliding
mounting bracket that can be removed and
placed on any of the frame's mounting rails. The
hoop bracket can slide up and down to any
position. Once in place, the bracket can be
locked in place to allow the hoop to move to any
location supported by the frame.