User Guide

, Inc. 5 | How Do I… - 107

Move your mouse onto the small button on

the extreme right of the Time Reference bar.

This is the Time Zoom In button. Click the

button to zoom the Stitches-in-Time

™

graphs in on the current selection.

Select a Single Stitch

Sometimes when you edit a design, you will find that jumps between

design elements have the wrong stitch type attributed to them. Most

often, the stitch is defined as a normal “stitch” but should be set as a

“jump stitch”. The following exercise shows you how to modify the

stitch type set for an individual stitch.

1 Select a Needle Point

Use one of the following methods to position the stitch cursor on

the needle point of your choice. You need to select the needle

point directly in front of the stitch you want to select.

Option One: Using the Space Window

Magnify the desired area of the Space window so that the

needle points of the design are large enough to select

individually. (See directions on page 104).

You can select a single needle point in the Stitches-in-Space

window by clicking on or near the needle point with the Lasso

tool. If the wrong needle point is selected, use the Select

Next Lassoed command (Edit > Lasso > Select next

Lassoed) until the desired needle point is selected. You can

also adjust which needle point is selected by using the left

and right arrow keys to move forward and backward needle

point by needle point. The selected needle point is the stitch

cursor for the design.

Option Two: Using the Time Window

Zoom in on the desired area of the Time window so that the

stitches appear as individual lines (see Zoom in the Time

graphs on page 105). Position your mouse cursor in front of

the stitch you wish to select and click the primary mouse

button to move the stitch cursor to this location.