Product Manual

www.buyersproducts.com
Phone [phone]
Fax [phone]
LT37 Hand Tool Rack
for Enclosed Landscape Trailers
Tools Required:
• 1/2" Wrench or Socket
• Electric Drill
• 7/32" Drill Bit
• 3/4" Plywood Shim Strips
• Shim Screws
1. Locate a suitable place on the wall to mount the hand tool
rack. The two racks should be mounted 32" apart on a 7°-10°
angle such that the tools (when removed) extend upward out
of the rear door of the trailer. It is recommended that you verify
that there is enough space to accept the tool with the largest
head (typically the leaf rake).
2. In order to mount this rack to the enclosed trailer, you must
first add 3/4" plywood shim strips to the walls. These shim
strips must be attached to at least two wall support studs with
suitable fasteners. If you don’t know what kind or length of fas-
tener to use contact your trailer dealer or manufacturer for their
recommendation.
3. After laying out the position of the rack and mounting the
shims, hold the hand tool racks against the shims and mark the
position of the four 5/16" holes in each rack. Make sure that
the two racks are parallel with each other and are at the proper
spacing. To verify that the racks are parallel, make sure that the
distance between the racks on both ends is 32". It may be nec-
essary to lightly tack one or both racks to the shims to deter-
mine the final positions.
3004482 Rev. B
Installation Instructions
Before you begin installing:
1. Read and understand these instructions
completely.
2. Verify that you have received all the parts
listed in the bill of materials.
CAUTION
Always wear safety glasses when using power tools.
4. Drill eight 7/32" pilot holes in the positions just marked for
the 5/16" lag screws. Be extremely careful not to drill through
the outside trailer wall.
5. Fasten the racks to the trailer wall with the eight 3/8" x
1-1/4" lag screws and eight 3/8" flat washers supplied.
6. Assemble the twelve grommets into the six 2" holes in each
bracket.
WARNING
Check under the trailer and/or fender for locations of brake
lines and electrical wiring etc., before drilling any holes. Any
damage to trailer during installation is installer’s sole respon-
sibility.
WARRANTY
Buyers Products Co. warrants all truck/trailer hardware manufac-
tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts
must be properly installed and used under normal conditions.
Any product which has been altered, including modification, mis-
use, accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of Buyers
Products Co. under this warranty is limited to repairing or replacing any
part or parts which are returned, prepaid, and are found to be defective
by Buyers Products Co. Authorization from Buyers Products Co. must
be obtained before returning any part. No charges for transportation
or labor performed on Buyers’ products will be allowed under this
warranty.
Bill of Materials
1 3004448 2 Angle, Tool Holder
2 3004167 12 Grommet, Rubber, for 2" Hole
3 - 8 Washer, 5/16 SAE Zn
4 - 8 Screw, Hex Head Lag, 5/16 x 1-1/4 Zn
ITEM PART NO. QTY. DESCRIPTION